New Step Added to the Instructions - What are the most important parts of install?

Initially when we did our studies we found the bores with smooth wearing and some with oval shapes at the bottom leaving a sharp edge.  We are hearing some results of orings prematurely wearing out in less than a year.  Along with that we are getting some reports of rough surfaces in the bores.  We added a step in the instructions to smooth out the bores a bit with 400-600 grit emery paper.  This is done by wrapping the paper around a dowel or drill and running it in and out a dozen time, cleaning out the bore and then installing our kit.  This appears to help the premature wear issue substantially.

We have also run across situation where people are not reading instructions.  Here are the biggest keys to a successful installation.

1. Smooth out the bores with emery paper.
2. Make sure you leave the plastic installation sleeve on during assembly.  We still have people who don't read the directions and remove it.
3. Once you carefully put the servo in up to where the bore touches the assembly sleeve, get everything ready to push it in place.  Make sure you push the servo in using one smooth-quick motion.  If you hesitate at all there is a chance the 1st oring will come out from under the sleeve an will get sheared off on the edge of the bore.

Remember we always ship at no cost replacement orings if needed.

That is it, happy shifting!

Andy